Are you a chicken owner looking to save money by building your own waterer? If so, then this post is for you! DIY Chicken Waterers are an easy way to keep your chickens hydrated without having to spend too much on store-bought ones. In this post, we’ll look at the different types of chicken waterers available, what materials you need for making your own, and the steps for creating your very own automatic chicken waterer in just seven easy steps. Let’s get started!
Introduction to DIY Chicken Waterers
DIY Chicken Waterers are simple devices that allow chickens to access water from a source such as a container or bucket. These devices can be built out of a variety of materials such as plastic buckets, PVC pipes, rubber hoses, etc. With a little bit of knowledge and effort, you can make one yourself that will last for years and cost significantly less than buying pre-made models.
Types of Chicken Waterers
There are two main types of chicken waterers: manual and automatic. Manual waterers require someone to manually fill them up with fresh water each day whereas automatic waterers have a self-filling mechanism which keeps the water levels steady. Automatic waterers also provide a higher level of hygiene as they reduce the chances of bacteria growth due to constant water exchange.
Materials Needed For DIY Chicken Waterers
To make your own DIY chicken waterer, you’ll need the following materials:
- 5 gallon bucket
- 3/4″ PVC pipe
- Nipple valves
- Hose clamps
- Water filter
- Faucet adapter
- Funnel
You may also need other tools depending on the type of waterer you choose to build. Make sure to research the specific requirements for each type before beginning the project.
Steps for Making Automatic Chicken Waterers
Once you have all the necessary supplies, follow these 7 steps to create your very own automatic chicken waterer:
1. Start by attaching the faucet adapter to the side of the 5 gallon bucket using hose clamps. This will act as an entry point for water into the bucket.
2. Connect the PVC pipe to the faucet adapter and run it through the lid of the bucket. Ensure that the end of the pipe reaches near the bottom of the bucket.
3. Install nipple valves along the length of the PVC pipe and place them at intervals so that every part of the inside of the bucket can be reached. The number of valves needed depends on how large your bucket is.
4. Place a water filter at the top of the pipe where it connects to the faucet adapter. This will ensure that only clean water flows into the bucket.
5. Once everything is securely connected, attach a funnel to the faucet adapter to easily pour in water without spilling it.
6. To test if everything is working correctly, turn on the tap and check if water starts flowing into the bucket via the nipples. Adjust the flow rate accordingly until all nipples are receiving enough water pressure.
7. Finally, place your new DIY chicken waterer in its designated area and watch as your chickens enjoy their fresh and clean water supply!
Conclusion
Making a DIY Chicken Waterer isn’t as difficult as it seems! With some basic materials and knowledge, you can create an automatic waterer that will provide your chickens with safe and hygienic drinking water for years to come. Now that you know how to make your own DIY chicken waterer, why not give it a try?
I am an inspired, life-long homesteader with a heart for simple, sustainable living. Growing up surrounded by farmland in the rural Midwest, I developed a deep respect for nature and the rewards of cultivating your own land. That’s why I’m passionate about helping others become homesteaders, too. Through my website therootedhomestead.com, I share my DIY tips, share inspiring stories of other homesteaders, and provide resources for anyone who dreams of growing their own food or living off the land. I hope to open a door to a more joyful, meaningful and purposeful life for all.
